Skip to main content

friendica (DFRN) - Link to source

This is my KBDCraft 60% typewriter.

Built from a Kit Lilith, with pieces from case Adam, along with some purchased parts and some I just had lying around. Plus some round "typewriter" keycaps from AliExpress.

It's also mostly hollow, so theoretically I could install a small PC like a Raspberry Pi or a NUC in there. But for now, it's good to use with a tablet.

A rear shot of a white, Lego-built typewriter. There is a tablet sitting on top as if it was the paper and is plugged in via USB.
A front-on shot of a white, Lego-built typewriter with an RGB mechanical keyboard for the keys. The keys have rounded keycaps. There is a tablet sitting on top as if it was the paper and is plugged in via USB.
A front-left shot of a white, Lego-built typewriter with an RGB mechanical keyboard for the keys. The keys have rounded keycaps. There is a tablet sitting on top as if it was the paper and is plugged in via USB.
A front-on shot of a white, Lego-built typewriter with an RGB mechanical keyboard for the keys. The keys have rounded keycaps. There is a 10" iPad sitting on top as if it was the paper. It's on a desk against a white wall.
A side-on shot of a white, Lego-built typewriter with an RGB mechanical keyboard for the keys. This time focussing on the rounded square look of the ribbon spools. Up this close you can see some of the blocks are yellowing with age.
A top-down shot of a white, Lego-built typewriter with an RGB mechanical keyboard for the keys. The keys have rounded keycaps. There is a tablet sitting on top as if it was the paper and is plugged in via USB. The keys and other reflections are reflected in the blank screen
⇧